After a few weeks testing and some time under a hot engine cover, I’ve changed out the prototype spool to a final, finished version using the same internal sprung reel.
Reproduction 3D printed spool
It works perfectly… as you raise the hood it pulls the support rod across with a satisfying ‘snap’
Disclaimer: 308restoration.com describes the restoration work I perform on my car and only my car. I am not a professional mechanic. The website content is presented for entertainment purposes only and should not be seen as any kind of advice, information, instruction or guidance for working on any other car. The opinions stated here are my own and no-one else’s.
Please leave a comment below and/or signup with your email address to never miss a future post.